ROOM TEMPERATURE SENSOR (for TMC, TMMR Made) > INSTALLATION |
| 1. INSTALL ROOM TEMPERATURE SENSOR (COOLER THERMISTOR) |
Connect the connector and cooler thermistor hose.
![]() |
Engage the 2 claws to install the room temperature sensor (cooler thermistor) as shown in the illustration.
| 2. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY |
w/o Driver Side Knee Airbag:
Engage the 5 clips and 3 guides.
w/ Driver Side Knee Airbag:
Engage the 4 claws, 7 clips and 3 guides.
Install the instrument panel sub-assembly with the 2 bolts <B>.
| 3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY |
Engage the claw and 2 guides to connect the hood lock control lever sub-assembly.
| 4. INSTALL FRONT PANEL GARNISH |
![]() |
Engage the 3 clips and 8 guides to install the front panel garnish LH.
| 5. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL (for RHD) |
w/ Smart Entry and Start System:
Connect the connector.
![]() |
Engage the 2 claws and 4 clips to install the upper instrument panel finish panel.
| 6. INSTALL INSTRUMENT SIDE PANEL |
Engage the 3 guides.
![]() |
Engage the 4 claws to install the instrument side panel LH as shown in the illustration.
| 7. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP |
| 8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY |
Engage the 2 clips.
Install the cowl side trim sub-assembly LH with the clip.
| 9. INSTALL FRONT DOOR SCUFF PLATE |
Engage the 10 claws to install the front door scuff plate LH.
| 10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for RHD with Smart Entry and Start System) |