Home › Vehicle Interior › HEATING / AIR CONDITIONING › ROOM TEMPERATURE SENSOR (for TMC, TMMR Made)

ROOM TEMPERATURE SENSOR (for TMC, TMMR Made) > INSTALLATION

for Preparation Click here



1. INSTALL ROOM TEMPERATURE SENSOR (COOLER THERMISTOR)
  1. Connect the connector and cooler thermistor hose.



    E315370
  1. Engage the 2 claws to install the room temperature sensor (cooler thermistor) as shown in the illustration.



2. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
  1. w/o Driver Side Knee Airbag:

    1. Engage the 5 clips and 3 guides.

  1. w/ Driver Side Knee Airbag:

    1. Engage the 4 claws, 7 clips and 3 guides.

  1. Install the instrument panel sub-assembly with the 2 bolts <B>.



3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
  1. Engage the claw and 2 guides to connect the hood lock control lever sub-assembly.



4. INSTALL FRONT PANEL GARNISH


    B386775
  1. Engage the 3 clips and 8 guides to install the front panel garnish LH.



5. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)
  1. w/ Smart Entry and Start System:

    1. Connect the connector.



    B281783
  1. Engage the 2 claws and 4 clips to install the upper instrument panel finish panel.



6. INSTALL INSTRUMENT SIDE PANEL
  1. Engage the 3 guides.



    B280321
  1. Engage the 4 claws to install the instrument side panel LH as shown in the illustration.



7. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
for LHD:
for RHD:


8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY
  1. Engage the 2 clips.

  1. Install the cowl side trim sub-assembly LH with the clip.



9. INSTALL FRONT DOOR SCUFF PLATE
  1. Engage the 10 claws to install the front door scuff plate LH.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for RHD with Smart Entry and Start System)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).