REAR DOOR COURTESY SWITCH (for TMC, TMMR Made) > INSTALLATION |
| 1. INSTALL REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY |
Using a T30 "TORX" socket wrench, install the rear door courtesy light switch assembly with the screw.
Connect the connector.
| 2. INSTALL REAR SIDE SEATBACK ASSEMBLY (for Fold Down Seat Type) |
Place the rear side seatback assembly LH in the cabin.
Engage the hook to install the rear side seatback assembly LH with the bolt.
Connect the rear seat outer belt assembly to the rear seat shoulder belt guide LH.
| 3. INSTALL REAR SEAT CUSHION LOCK HOOK (for Fold Down Seat Type) |
![]() |
Engage the 2 claws to install a new rear seat cushion lock hook as shown in the illustration.
| 4. INSTALL REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type) |
Place the rear seat cushion assembly in the cabin.
w/ Seat Heater System:
Engage the 2 clamps.
Connect the connector.
![]() |
Engage the 2 hooks of the rear seat cushion assembly to the vehicle body as shown in the illustration.
Confirm that the rear seat cushion assembly is firmly installed.
| 5. INSTALL REAR SEATBACK ASSEMBLY (for Fold Down Seat Type) |
Place the rear seatback assembly LH in the cabin.
w/ Seat Heater System:
Engage the clamp.
Connect the connector.
Install the rear seatback assembly LH with the 2 bolts.
![]() |
Engage the fastener as shown in the illustration.
Raise the rear seatback assembly LH.
Connect the rear seat outer belt assembly to the rear seat center shoulder belt guide.
| 6. INSTALL REAR SEAT HEADREST ASSEMBLY (for Fold Down Seat Type) |
| 7. INSTALL REAR SEATBACK ASSEMBLY (for Reclining Seat Type) |
Place the rear seatback assembly LH in the cabin.
Install the rear seatback assembly LH with the 2 bolts and 2 nuts.
Engage the 2 hooks to install the cover.
Connect the 2 rear seat belts to the 2 rear seat shoulder belt guides.
w/ Rear Seat Side Airbag:
Connect each connector and clamp to the child restraint anchor bracket sub-assembly LH.
| 8. INSTALL REAR SEATBACK COVER (for Reclining Seat Type) |
Engage the 4 claws to install the 2 rear seatback covers.
| 9. INSTALL REAR SEAT CUSHION LOCK HOOK (for Reclining Seat Type) |
![]() |
Engage the 2 claws to install a new rear seat cushion lock hook as shown in the illustration.
| 10. INSTALL REAR SEAT CUSHION ASSEMBLY (for Reclining Seat Type) |
Place the rear seat cushion assembly in the cabin.
Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly.
Connect the 2 seat heater connectors.
![]() |
Engage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly to the 2 rear seat cushion lock hooks as shown in the illustration.
Confirm that the rear seat cushion assembly is securely installed.
| 11. INSTALL REAR SEAT HEADREST ASSEMBLY (for Reclining Seat Type) |
| 12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Rear Seat Side Airbag) |
| 13. INSPECT SRS WARNING LIGHT (w/ Rear Seat Side Airbag) |