Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY (for TMMK Made)

REAR COMBINATION LIGHT ASSEMBLY (for TMMK Made) > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. INSTALL REAR COMBINATION LIGHT ASSEMBLY


    E300998
  1. Engage the guide to temporarily install the rear combination light assembly as shown in the illustration.

  1. Install the rear combination light assembly with the 3 nuts.

  1. Engage the clamp.

  1. Connect the 2 connectors.



2. INSTALL LUGGAGE COMPARTMENT INNER TRIM COVER
  1. Engage the fastener.

  1. Install the luggage compartment inner trim cover LH with the 2 clips.



3. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK


    B380710E01
  1. Engage the pin to install the No. 1 luggage compartment trim hook.
    Text in Illustration 
    *a
    Pin



4. INSTALL REAR FLOOR FINISH PLATE


    B380709
  1. Engage the 4 clips to install the rear floor finish plate as shown in the illustration.

  1. Install the 5 clips.



5. INSTALL SPARE WHEEL COVER ASSEMBLY
  1. Install the spare wheel cover assembly.



6. INSTALL REAR BUMPER ASSEMBLY
(Click here)