Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY (for TMMK Made)

REAR COMBINATION LIGHT ASSEMBLY (for TMMK Made) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The following procedure is for the LH side.



1. REMOVE REAR BUMPER ASSEMBLY
(Click here)


2. REMOVE SPARE WHEEL COVER ASSEMBLY
  1. Remove the spare wheel cover assembly.



3. REMOVE REAR FLOOR FINISH PLATE


    B380707
  1. Remove the 5 clips.



    B380708
  1. Disengage the 4 clips and remove the rear floor finish plate as shown in the illustration.



4. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK


    B380706E01
  1. Push in the pin and remove the No. 1 luggage compartment trim hook.
    Text in Illustration 
    *a
    Pin



5. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER


    B380705
  1. Remove the 2 clips.

  1. Disengage the fastener and remove the luggage compartment inner trim cover LH.



6. REMOVE REAR COMBINATION LIGHT ASSEMBLY


    E300995
  1. Disconnect the 2 connectors.

  1. Disengage the clamp.



    E300996
  1. Remove the 3 nuts and rear combination light assembly.



    E300997
  1. Disengage the guide and remove the rear combination light assembly as shown in the illustration.