AFS OFF SWITCH > REMOVAL |
| 1. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column) |
Disable the auto away/return function by changing the customize parameter (Click here).
Turn the ignition switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.
| 2. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP |
![]() |
Disconnect the front door opening trim weatherstrip LH.
| 3. REMOVE INSTRUMENT SIDE PANEL |
![]() |
Using a moulding remover, disengage the 4 claws as shown in the illustration.
![]() |
Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.
| 4. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY |
![]() |
Disengage the 4 clips to remove the No. 1 instrument panel register assembly as shown in the illustration.
| 5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
for Manual Tilt and Manual Telescopic Steering Column:
Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.
![]() |
Using a moulding remover, disengage the 4 clips and 2 guides.
for LHD:
![]() |
Disengage the 3 claws, 7 clips and 4 guides.
for RHD:
![]() |
Disengage the 4 claws, 5 clips and 4 guides as shown in the illustration.
Disconnect each connector.
![]() |
Remove the instrument cluster finish panel assembly as shown in the illustration.
| 6. REMOVE HEADLIGHT SWIVEL MAIN SWITCH (AFS OFF SWITCH) |
![]() |
Disengage the 2 claws and remove the headlight swivel main switch (AFS OFF switch).