Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR (for TMMK Made)

HEIGHT CONTROL SENSOR (for TMMK Made) > INSTALLATION

for Preparation Click here



1. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
  1. Engage the clamp.

  1. Install the rear height control sensor sub-assembly with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Install the nut.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the connector.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. INITIALIZE HEIGHT CONTROL SENSOR SIGNAL
(Click here)


4. ADJUST HEADLIGHT AIMING
(Click here)