Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR (for TMMK Made)

HEIGHT CONTROL SENSOR (for TMMK Made) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY


    E315255
  1. Disconnect the connector.

  1. Remove the nut and 2 bolts.

  1. Disengage the clamp and remove the rear height control sensor sub-assembly.

    NOTICE:
    Do not drop the rear height control sensor sub-assembly. If it is dropped, replace it with a new one.