OIL PUMP > REMOVAL |
| 1. REMOVE ENGINE AND TRANSAXLE |
| 2. REMOVE ENGINE WIRE |
| 3. REMOVE IGNITION COIL ASSEMBLY |
Disconnect the 4 ignition coil assembly connectors.
![]() |
Remove the 4 bolts and 4 ignition coil assemblies.
| 4. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY |
![]() |
Remove the 16 bolts, 3 seal washers, cylinder head cover and gasket.
![]() |
Remove the 3 gaskets from the camshaft bearing caps.
| 5. REMOVE CRANKSHAFT POSITION SENSOR |
![]() |
Disconnect the crankshaft position sensor connector.
Remove the bolt and crankshaft position sensor.
| 6. REMOVE CRANKSHAFT PULLEY |
![]() |
Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.
| *a | Hold |
| *b | Turn |
![]() |
Using SST and the pulley bolt, remove the crankshaft pulley.
| *1 | Pulley Bolt |
| *a | Hold |
| *b | Turn |
| 7. REMOVE ENGINE MOUNTING BRACKET RH |
![]() |
Remove the 5 bolts and engine mounting bracket RH.
| 8. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY |
![]() |
Remove the bolt and V-ribbed belt tensioner.
| 9. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY |
![]() |
Remove the 17 bolts and 2 nuts.
![]() |
Remove the timing chain cover by prying between the timing chain cover and cylinder head, camshaft housing, cylinder block and stiffening crankcase with a screwdriver as shown in the illustration.
![]() |
Remove the 3 gaskets from the stiffening crankcase.
| 10. REMOVE TIMING CHAIN COVER OIL SEAL |
![]() |
Using a screwdriver and wooden block, pry out the oil seal.
| *1 | Wooden Block |