U0100
| There is no effect on vehicle behavior.
| If the following conditions are met, it is determined that the malfunction is not in the direct line (NE) but in CAN communication.
- When the engine switch is pressed, the system controls the engine based on the engine speed signal via direct line, causing the engine to stop cranking.
- When the engine switch is pressed and held, the system controls the engine based on the engine speed signal via direct line, causing the engine to stop cranking.
If the following conditions are met, it is determined that there is a malfunction in both CAN communication and the direct line (NE).
- When the engine switch is pressed, the engine stops cranking after 6 seconds.
- When the engine switch is pressed and held, the engine remains cranking for up to 30 seconds.
|