Home › Power Source / Network ยท POWER DISTRIBUTION › INTEGRATION RELAY

INTEGRATION RELAY > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE NO. 1 RELAY BLOCK COVER


    B279031
  1. Disengage the 2 claws and remove the No. 1 relay block cover as shown in the illustration.



4. REMOVE ENGINE ROOM JUNCTION BLOCK ASSEMBLY


  1. Disengage the 2 claws as shown in the illustration.


    B279033E02


    Text in Illustration 
    *1
    Protective Tape
    *a
    Pulled Position

  1. Using pliers, pull up the engine room junction block assembly at the position indicated in the illustration and disconnect the 4 connectors from the engine room relay block assembly.

    NOTICE:
    When pulling a engine room junction block assembly, take care not to damage the engine room junction block assembly.

    HINT:
    Tape the pliers tip before use.



    B282874
  1. Disconnect the 2 connectors and remove the engine room junction block assembly.

    NOTICE:
    1. Do not drop or allow any impact on parts.
    2. Do not touch the connector.