Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM

DTC    C1611    ECU Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored if the rear television camera assembly judges that there is an internal malfunction as a result of its self check.

HINT:
The rear television camera assembly stores different types of information during initialization. If the rear television camera assembly cannot read the stored information when it is activated, the rear television camera assembly judges that there is an internal malfunction and stores this DTC.


DTC No.
DTC Detection Condition
Trouble Area
C1611
When one of the following conditions is met:
  1. EEPROM status (Initial read) malfunction
  2. CPU communication malfunction
  3. ASIC output malfunction
Rear television camera assembly

INSPECTION PROCEDURE

NOTICE:
  1. If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point" (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).

1.READ VALUE USING GTS
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Chassis / Advanced Parking Guidance/Parking Assist Monitor / Data List.

  1. According to the display on the GTS, read the Data List.

    Advanced Parking Guidance/Parking Assist Monitor 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    EEPROM Status (Initial read)
    Rear television camera assembly information/OK or NG
    OK: Rear television camera assembly normal
    NG: Rear television camera assembly abnormal
    -
    CPU Communication Status
    Rear television camera assembly information/OK or NG
    OK: Rear television camera assembly normal
    NG: Rear television camera assembly abnormal
    -
    ASIC Output Status
    Output condition of video signal/OK or NG
    OK: Output condition of video signal normal
    NG: Output condition of video signal abnormal
    -

    Result:
    Result
    Proceed to
    OK is displayed for all items
    A
    NG is displayed for EEPROM status (Initial read)
    NG is displayed for items other than EEPROM status (Initial read)
    B



B
REPLACE REAR TELEVISION CAMERA ASSEMBLY (Click here)
A


2.PERFORM CALIBRATION
  1. Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.

    1. Rear television camera assembly optical axis adjustment (back camera position setting) (Click here).

    2. Steering angle setting (Click here).


NEXT


3.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check that no DTCs are output (Click here).

    HINT:
    1. If DTC C1611 is output, perform the procedure to allow the rear television camera assembly to store the vehicle information again.
    2. If DTC C1611 is still output after performing the procedure to make the rear television camera assembly store the vehicle information 3 times, replace the rear television camera assembly.

    Result:
    Result
    Proceed to
    DTC C1611 is output
    A
    DTC C1611 is not output
    B



B
END
A

REPLACE REAR TELEVISION CAMERA ASSEMBLY (Click here)