Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

DTC    U0126    Lost Communication with Steering Angle Sensor Module

DTC    U0129    Lost Communication with Brake System Control Module

DTC    U0131    Lost Communication with Power Steering Control Module

DTC    U0140    Lost Communication with Body Control Module

DTC    U0163    Lost Communication with Navigation Control Module

DTC    U1110    Lost Communication with Intuitive Parking Assist Module

for Preparation Click here


DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the rear television camera assembly.

HINT:
If CAN communication system DTCs are stored, they may also be stored in other systems.


DTC No.
DTC Detection Condition
Trouble Area
U0100
Lost communication with ECM
CAN communication system
U0126
Lost communication with steering sensor
U0129
Lost communication with brake actuator assembly (skid control ECU)
U0131
Lost communication with power steering ECU assembly
U0140
Lost communication with main body ECU (multiplex network body ECU)
U0163
Lost communication with radio and display receiver assembly
U1110
Lost communication with clearance warning ECU assembly

INSPECTION PROCEDURE

NOTICE:
  1. If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point" (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).

1.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check that no DTCs are output (Click here).

    HINT:
    1. If CAN communication system DTCs are stored, they may also be stored in other systems.
    2. If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
    3. If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTCs are output
    A
    No DTCs are output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (Click here)