Home › Drivetrain ยท U761E AUTOMATIC TRANSMISSION / TRANSAXLE › PARK / NEUTRAL POSITION SWITCH

PARK / NEUTRAL POSITION SWITCH > ADJUSTMENT

for Preparation Click here



1. REMOVE TRANSMISSION CONTROL SHAFT LEVER
(Click here)


2. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    C316902
  1. Loosen the 2 bolts of the park/neutral position switch assembly.



    C135733E10
  1. Align the protrusions of the park/neutral position switch assembly as shown in the illustration.
    Text in Illustration 
    *a
    Protrusion

  1. Hold the park/neutral position switch assembly in position and tighten the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

    NOTICE:
    After installing the park/neutral position switch assembly, confirm that the 2 protrusions on the park/neutral position switch assembly are aligned.



3. INSTALL TRANSMISSION CONTROL SHAFT LEVER
(Click here)


4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION
  1. Apply the parking brake.

  1. Turn the engine switch on (IG).

  1. Depress the brake pedal and check that the engine starts when the shift lever is in N or P, but does not start in any other position.

  1. Check that the back-up lights come on when the shift lever is moved to R, but do not come on in any other position. If the operation is not as specified, check the park/neutral position switch assembly for continuity.