Rotate the crankshaft pulley and align the water pump pulley hole with the drain plug.
Text in Illustration
*a
| Water Pump Pulley
|
*b
| Drain Plug
|
*c
| Water Pump Pulley Hole
|
- HINT:
- The drain plug is at the bottom of the engine water pump assembly.
- Use a mirror to check that the water pump pulley hole and drain plug are aligned.
Wrap a thin paper towel around an L-shaped tool such as a hexagon wrench, and insert it into the water pump pulley hole.
Text in Illustration
*a
| Paper Towel
|
- HINT:
- Use a 3 mm (0.118 in.) hexagon wrench.
- The diameter of the water pump pulley hole is 9 mm (0.354 in.).
- The distance from the water pump pulley hole to the drain plug is 18 mm (0.709 in.).
Move the hexagon wrench as shown in the illustration, and press the paper towel against the engine coolant (solid matter) adhered to the drain plug or the edge of the drain plug, and check the condition of the paper towel.
Text in Illustration
*a
| Hexagon Wrench
|
- HINT:
- If the paper towel is wet, replace the engine water pump assembly.
- If the paper towel is dry, clean the area around the engine water pump assembly.