BRAKE MASTER CYLINDER (for RHD) > INSTALLATION |
| 1. INSTALL BRAKE MASTER CYLINDER O-RING |
Install a new brake master cylinder O-ring to the brake master cylinder sub-assembly.
| 2. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY |
![]() |
Apply a light layer of a grease enclosed with a new brake master cylinder sub-assembly or lithium soap base glycol grease to the circumference of the brake master cylinder sub-assembly and inner surface of the brake booster assembly as shown in the illustration.
![]() | Apply Grease |
![]() |
Install the brake master cylinder sub-assembly and vacuum check valve bracket to the brake booster assembly with the 2 nuts.
| *1 | Master Cylinder Piston |
![]() |
Using a union nut wrench, connect the 2 brake lines to the brake master cylinder sub-assembly.
| *a | Torque Wrench Fulcrum Length |
Connect the reservoir level switch connector.
| 3. BLEED BRAKE SYSTEM |
| 4. INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY |
Install the front outer cowl top panel sub-assembly with the 10 bolts.
Engage the 2 clamps to install the wire harness to the front outer cowl top panel sub-assembly.
| 5. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY |