Home › Brake › BRAKE SYSTEM (OTHER) › VACUUM PUMP

VACUUM PUMP > INSTALLATION

for Preparation Click here



1. INSTALL VACUUM PUMP ASSEMBLY


  1. When installing a new vacuum pump assembly:



      C314619E01
    1. Apply engine oil to the No. 3 O-ring.
      Text in Illustration 
      *1
      No. 2 O-ring
      *2
      No. 3 O-ring
      V100135
      Engine Oil

      NOTICE:
      Do not apply engine oil to the No. 2 O-ring.



  1. When reusing the vacuum pump assembly:



      C314619E01
    1. Install a new No. 2 O-ring to the vacuum pump assembly.
      Text in Illustration 
      *1
      No. 2 O-ring
      *2
      No. 3 O-ring
      V100135
      Engine Oil

    2. Apply engine oil to a new No. 3 O-ring and install it to the vacuum pump assembly.

      NOTICE:
      Do not apply engine oil to the No. 2 O-ring.



    C314608E01
  1. Apply engine oil to the inner surface of the installation hole.
    Text in Illustration 
    *a
    Coupling Teeth
    *b
    Groove
    V100135
    Engine Oil

  1. Align the coupling teeth of the vacuum pump assembly with the groove of the camshaft and install the vacuum pump assembly with the 4 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

    NOTICE:
    After tightening the bolts, ensure that the contact surface of the vacuum pump assembly is flush with the cylinder head.



2. CONNECT UNION TO CHECK VALVE HOSE
  1. Connect the union to check valve hose to the vacuum pump assembly, and slide the clip to secure it.



3. INSTALL EGR VALVE WITH COOLER ASSEMBLY



4. OPERATION CHECK
(Click here)