Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY (for TMMK Made)

FRONT SEAT SIDE AIRBAG ASSEMBLY (for TMMK Made) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT AIRBAG ASSEMBLY

CAUTION:
  1. The nuts must not be reused.
  2. Make sure that the front seatback frame sub-assembly is not deformed. If it is, replace it with a new one.

  1. Install the front seat airbag assembly with 2 new nuts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Engage the 2 clamps.



2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Manual Seat)
  1. Temporarily install the separate type front seatback cover with pad.

  1. Engage the 4 claws to install the 2 front seat headrest supports.

  1. Engage the 2 hooks.

    CAUTION:
    1. For vehicles with a front seat airbag assembly, the separate type front seatback cover must be securely installed. Otherwise, the front seat airbag assembly may not deploy properly.
    2. Make sure that the strap is not twisted after engaging the 2 hooks.
    3. Engage the 2 hooks securely.

  1. Turn back the separate type front seatback cover.

  1. Engage the 2 fasteners.

  1. Engage the hook.



3. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD (for Power Seat)
  1. Temporarily install the separate type front seatback cover with pad.

  1. Engage the 4 claws to install the 2 front seat headrest supports.

  1. Engage the 2 hooks.

    CAUTION:
    1. For vehicles with a front seat airbag assembly, the separate type front seatback cover must be securely installed. Otherwise, the front seat airbag assembly may not deploy properly.
    2. Make sure that the strap is not twisted after engage the 2 hooks.
    3. Engage the 2 hooks securely.

  1. Turn back the separate type front seatback cover.

  1. Engage the 2 fasteners.

  1. Engage the hook.



4. CONNECT AIRBAG WIRE HARNESS (for Manual Seat)
  1. Engage the claw and 3 clamps to connect the airbag wire harness.

  1. Connect the 2 rubber bands of the separate type front seatback cover with pad.



5. CONNECT AIRBAG WIRE HARNESS (for Power Seat)


  1. w/ Seat Heater System:



      B280156E01
    1. Connect the connector (E).

    2. Engage the clamp (F).

  1. Engage the claw (D) and 3 clamps (C) to Connect the airbag wire harness.

  1. Engage the clamp (B).

  1. Connect the connector (A).

  1. Connect the 2 rubber bands of the separate type front seatback cover with pad.



6. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat)
(Click here)


7. INSTALL FRONT SEAT ASSEMBLY (for Power Seat)
(Click here)


8. PERFORM DIAGNOSTIC SYSTEM CHECK
(Click here)