Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for TMMK Made Manual Seat)

FRONT SEAT ASSEMBLY (for TMMK Made Manual Seat) > INSTALLATION

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. INSTALL FRONT SEAT ASSEMBLY
  1. Place the front seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect each connector and clamp under the front seat assembly.

  1. Temporarily install the front seat assembly with the 4 bolts.

  1. Lift up the seat track adjusting handle and move the front seat assembly to the rearmost position.



    B381189E01
  1. Tighten the 2 bolts on the front side of the front seat assembly.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    NOTICE:
    Tighten the bolts in the order indicated in the illustration.

  1. Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.



    B381190E01
  1. Tighten the 2 bolts on the rear side of the front seat assembly.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    NOTICE:
    Tighten the bolts in the order indicated in the illustration.



2. INSPECT SEAT SLIDE ADJUSTER LOCKS
  1. During the sliding operation of the front seat assembly, check that the left and right adjusters move together smoothly and lock simultaneously. If the seat adjusters do not lock simultaneously, loosen the front seat assembly installation bolts to adjust the adjuster position.



3. INSTALL REAR INNER SEAT TRACK BRACKET COVER
  1. Lift up the seat track adjusting handle and move the front seat assembly to the foremost position.

  1. Engage the 2 claws to install the rear inner seat track bracket cover.



4. INSTALL REAR OUTER SEAT TRACK BRACKET COVER
  1. Engage the 2 claws to install the rear outer seat track bracket cover.



5. INSTALL FRONT SEAT HEADREST ASSEMBLY


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



7. PERFORM ZERO POINT CALIBRATION AND SENSITIVITY CHECK
(Click here)


8. INSPECT SRS WARNING LIGHT
(Click here)