Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Navigation Receiver Type)

DTC    B1579    Voice Recognition Microphone Disconnected

for Preparation Click here


DESCRIPTION

The navigation receiver assembly and roof console box assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.
This DTC is stored when a microphone connection detection signal line is disconnected.

DTC Code
DTC Detection Condition
Trouble Area
B1579
Microphone signal is lost
  1. Roof console box assembly (telephone microphone assembly)
  2. Navigation receiver assembly
  3. Harness or connector

WIRING DIAGRAM


E300236E04


INSPECTION PROCEDURE

1.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E289390E06
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I67-19 (MIN-) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Component with harness connected
    (Navigation Receiver Assembly)

    Result:
    Result
    Proceed to
    OK
    A
    NG (for TMMK Made)
    B
    NG (for TMC Made)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (for TMMK Made) (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (for TMC Made) (Click here)
A


2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY))
  1. Disconnect the I67 navigation receiver assembly connector.

  1. Disconnect the S7 roof console box assembly (telephone microphone assembly) connector (for TMC Made).
    Disconnect the S14 roof console box assembly (telephone microphone assembly) connector (for TMMK Made).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I67-6 (SNS2) - S7-15 (SNS2)*1
    I67-6 (SNS2) - S14-15 (SNS2)*2
    Always
    Below 1 Ω
    I67-19 (MIN-) - S7-12 (MCO-)*1
    I67-19 (MIN-) - S14-12 (MCO-)*2
    Always
    Below 1 Ω
    I67-6 (SNS2) - Body ground
    Always
    10 kΩ or higher
    I67-19 (MIN-) - Body ground
    Always
    10 kΩ or higher

    1. *1: for TMC Made
      *2: for TMMK Made



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT ROOF CONSOLE BOX ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY)
  1. Remove the roof console box assembly (telephone microphone assembly) (for TMMK Made) (Click here).
    Remove the roof console box assembly (telephone microphone assembly) (for TMC Made) (Click here).



    E187117E58
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    15 (SNS2) - 12 (MCO-)
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Roof Console Box Assembly (Telephone Microphone Assembly))

    Result:
    Result
    Proceed to
    OK (for TMMK Made)
    A
    OK (for TMC Made)
    B
    NG (for TMMK Made)
    C
    NG (for TMC Made)
    D



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (for TMC Made) (Click here)

C
REPLACE ROOF CONSOLE BOX ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY) (for TMMK Made) (Click here)

D
REPLACE ROOF CONSOLE BOX ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY) (for TMC Made) (Click here)
A

REPLACE NAVIGATION RECEIVER ASSEMBLY (for TMMK Made) (Click here)