Home › Vehicle Interior › HEATING / AIR CONDITIONING › PTC HEATER ASSEMBLY

PTC HEATER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL QUICK HEATER ASSEMBLY


    E234660
  1. Insert the quick heater assembly as shown in the illustration.

  1. Install the 2 screws.

  1. Engage the 4 clamps.

  1. Install the quick heater assembly with the bolt.

    Torque:
    20 N*m{ 199 kgf*cm , 14 ft.*lbf }

  1. Connect the quick heater connector.



2. INSTALL NO. 1 AIR DUCT SUB-ASSEMBLY


    E227192
  1. Engage the guide and 2 claws to install the No. 1 air duct sub-assembly as shown in the illustration.



3. INSTALL FLOOR CARPET BRACKET RH
  1. Engage the 2 guides.

  1. Install the floor carpet bracket RH with the 2 clips.



4. INSTALL SHIFT LEVER SUPPORT
(Click here)


5. INSTALL RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/o Navigation System)
(Click here)


6. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/ Navigation System)
(Click here)


7. INSTALL FRONT SEAT ASSEMBLY LH (for Manual Seat)
(Click here)


8. INSTALL FRONT SEAT ASSEMBLY LH (for Power Seat)
(Click here)


9. INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat)

HINT:
Use the same procedure as for the LH side.



10. INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat)

HINT:
Use the same procedure as for the LH side.