Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

BLIND SPOT MONITOR SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



DESCRIPTION
  1. Blind spot monitor data and the Diagnostic Trouble Codes (DTCs) can be read from the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be malfunctioning, use the GTS to check for malfunctions and to repair it.


CHECK DLC3
  1. Check the DLC3 (Click here)


DIAGNOSIS FUNCTION
  1. The blind spot monitor system displays an error message on the multi-information display to inform the driver that the system is unavailable either temporarily or due to a malfunction.

    1. When the system is unavailable temporarily:
      Multi-information display displays "BSM not available".
    2. When the system is unavailable due to malfunction:
      Multi-information display displays "Check BSM System".


ABNORMALITY HISTORY

HINT:
The abnormality history for a blind spot monitor sensor can be displayed or cleared.

  1. Check abnormality history

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Turn the blind spot monitor main switch (warning canceling switch assembly) on.

    5. Enter the following menus: Body Electrical / Blind spot monitor Master or Blind spot monitor Slave / Utility / BSM Master Abnormal History or BSM Slave Abnormal History

    6. Check the results displayed for the abnormality history check.

      HINT:
      1. If "Yes" is displayed, check the suspected area column for each item.
      2. Abnormality history is stored only for the blind spot monitor sensor for which an abnormality has been detected.
      3. If "No" is displayed, proceed to the next suspected area shown in the Problem Symptoms Table (Click here).


      Abnormality History Table 
      Tester Display
      Item Explanation
      Suspected Area
      History of Module Blockage
      History of blind spot monitor sensor detection problems due to snow, rain etc. on the bumper
      1. Check if a bumper compatible with the blind spot monitor (such as an original equipment bumper) is installed
      2. Check if any foreign matter is attached to the bumper
      3. Check if any foreign matter is present between the bumper and sensors
      History of Low Voltage
      History of low supply battery voltage from battery to the blind spot monitor sensor
      Power Source Circuit (Click here)
      History of High Voltage
      History of high supply battery voltage from battery to the blind spot monitor sensor
      History of Low Temperature
      History of low temperature for the blind spot monitor sensor
      Check the outside temperature
      History of High Temperature
      History of high temperature for the blind spot monitor sensor

  2. Clearing abnormality history

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Turn the blind spot monitor main switch (warning canceling switch assembly) on.

    5. Enter the following menus: Body Electrical / Blind spot monitor Master or Blind spot monitor Slave / Utility / BSM Master Abnormal History or BSM Slave Abnormal History

    6. Clear the BSM Master Abnormal History and/or BSM Slave Abnormal History.