DTC U1331 Software Incompatibility with Body Control Module "B" |
| DTC No. | DTC Detection Condition | Trouble Area |
| U1331 | Destination information of the main body ECU (multiplex network body ECU) and blind spot monitor sensor do not match. |
|
| 1.CHECK PART NUMBER (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)) |
Check the main body ECU (multiplex network body ECU) part number.
Check if the part number of the main body ECU (multiplex network body ECU) installed on the vehicle is correct.
|
| ||||
| OK | |
| 2.CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
| Result | Proceed to |
| No DTCs are output. | A |
| DTC is output from the blind spot monitor sensor RH (Master). | B |
| DTC is output from the blind spot monitor sensor LH (Slave). | C |
|
| ||||
|
| ||||
| A | ||
| ||