Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    U1331    Software Incompatibility with Body Control Module "B"

for Preparation Click here


DESCRIPTION

This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors.

DTC No.
DTC Detection Condition
Trouble Area
U1331
Destination information of the main body ECU (multiplex network body ECU) and blind spot monitor sensor do not match.
  1. Main body ECU (multiplex network body ECU)
  2. Blind spot monitor sensor RH
  3. Blind spot monitor sensor LH

INSPECTION PROCEDURE

NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.

1.CHECK PART NUMBER (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
  1. Check the main body ECU (multiplex network body ECU) part number.

    1. Check if the part number of the main body ECU (multiplex network body ECU) installed on the vehicle is correct.

      OK:
      The part number is correct.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
OK


2.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    Result:
    Result
    Proceed to
    No DTCs are output.
    A
    DTC is output from the blind spot monitor sensor RH (Master).
    B
    DTC is output from the blind spot monitor sensor LH (Slave).
    C



B
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)

C
REPLACE BLIND SPOT MONITOR SENSOR LH (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)