Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    U0232    Lost Communication with Blind Spot Monitor Slave Module

for Preparation Click here


DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH judges that there is a communication error with the blind spot monitor sensor LH.

DTC No.
DTC Detection Condition
Trouble Area
U0232
The blind spot monitor sensor RH cannot receive signals from the blind spot monitor sensor LH.
  1. CAN communication line
  2. Blind spot monitor sensor RH
  3. Blind spot monitor sensor LH

WIRING DIAGRAM


E233765E21


INSPECTION PROCEDURE

NOTICE:
  1. When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - BLIND SPOT MONITOR SENSOR LH)
  1. Disconnect the O43 blind spot monitor sensor RH connector.

  1. Disconnect the T17 blind spot monitor sensor LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    O43-1 (CA2P) - T17-1 (CA2P)
    Always
    Below 1 Ω
    O43-6 (CA2N) - T17-6 (CA2N)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE CAN LINE OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - BATTERY)
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T17-5 (BLB) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR LH - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T17-10 (BLGD) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE BLIND SPOT MONITOR SENSOR LH
  1. Replace the blind spot monitor sensor LH with a new or known good one (Click here).


NEXT


5.CHECK DTC
  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
REPLACE BLIND SPOT MONITOR SENSOR RH (Click here)
OK

END (BLIND SPOT MONITOR SENSOR LH WAS DEFECTIVE)