Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM

DTC    C1ABB    Blind Spot Monitor Master Module Beam Axis Inspection Incomplete

for Preparation Click here


DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH.

HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.


DTC No.
DTC Detection Condition
Trouble Area
C1ABB
A beam axis inspection has not been performed.
Blind spot monitor sensor RH

INSPECTION PROCEDURE

1.PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)
  1. Change the blind spot monitor sensor RH to Test Mode using the GTS.

    HINT:
    Refer to Blind Spot Monitor Beam Axis Inspection (Click here).


NEXT

END