Home › Vehicle Interior › POWER OUTLETS (INT) › WIRELESS CHARGING SYSTEM

WIRELESS CHARGING SYSTEM > TERMINALS OF ECU

for Preparation Click here



MOBILE WIRELESS CHARGER CRADLE ASSEMBLY

E216115E01


Tester Connection
Wiring Color
Terminal Description
Condition
Specified Condition
I194-6 (B+) - I194-1(PGND)
W - W-B
Power source (+B)
Engine switch off
11 to 14 V
I194-5 (ACC) - I194-1 (PGND)
GR - W-B
Power source (ACC)
Engine switch on (ACC)
11 to 14 V
Engine switch off
Below 1 V
I194-1 (PGND) - Body ground
W-B - Body ground
Ground
Always
Below 1 V
I194-10 (TAIL) - I194-1 (PGND)
G - W-B
Illumination signal
Light control switch in off position
Below 1 V
Light control switch in tail or head position
11 to 14 V
I194-7 (DIS) - Body ground
L - Body ground
Charging suspension signal
For 5 seconds after turning engine switch from off to on (ACC)*1
4.5 to 6.0 V
Device being charged
Below 1 V
Charging suspended due to smart entry and start system status*2
4.5 to 6.0 V
  1. *1: When the engine switch is turned from off to on (ACC), the mobile wireless charger cradle assembly monitors the charging suspension signal for 5 seconds. If the charging suspension signal is not 4 V or more for 0.8 seconds or more during monitoring, the mobile wireless charger cradle assembly determines that there is an open in the charging suspension signal line, blinks (pattern 1) the indicator light (amber), and prohibits operation until the engine switch is turned from off to on (ACC) again.
  2. *2: For details about conditions when the certification ECU (smart key ECU assembly) sends the charging suspension signal (Click here).