Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows)

POWER WINDOW CONTROL SYSTEM (for Models with Jam Protection Function on 4 Windows) > Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated)

for Preparation Click here


DESCRIPTION

If a door glass or a power window regulator motor assembly does not operate smoothly, the catch protection function may be triggered automatically, resulting in the auto down operation being unable to fully open the window.

INSPECTION PROCEDURE

HINT:
This symptom may occur for any of the windows.

NOTICE:
  1. If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system (Click here).
  2. If a power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system (Click here).

1.PERFORM INITIALIZATION (APPLICABLE LOCATION)
  1. Initialize the power window regulator motor assembly (applicable location) (Click here).


NEXT


2.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (APPLICABLE LOCATION))
  1. Check that power window move when the auto up and down functions of the multiplex network master switch assembly, power window regulator switch assembly or rear power window regulator switch assembly is operated (Click here).

    OK:
    Auto up and down functions are normal (applicable location).



NG
Go to step 3
OK

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

3.CHECK WINDOW GLASS SLIDING MOVEMENT (APPLICABLE LOCATION)
  1. Remove the window regulator.

  1. Install the window glass onto the door glass run.

  1. Check if the door window regulator operates smoothly.

  1. Check that the window glass slides smoothly when sliding it down by hand.

    NOTICE:
    Make sure to perform initialization (Click here).

    OK:
    Door window glass slides smoothly.

    Result:
    Result
    Proceed to
    NG
    A
    OK (Driver door power window)
    B
    OK (Front passenger door power window)
    B
    OK (Rear LH door power window)
    C
    OK (Rear RH door power window)
    C

    HINT:
    Ensure the following:
    1. The window glass fits with the glass run without improper contact or deformation.
    2. Foreign objects are not caught in the glass run.
    3. The glass run is not misaligned.
    4. The belt moulding or inner weatherstrip is not caught.
    5. The glass is not tilted and does not catch.



B
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR OR FRONT PASSENGER DOOR) (Click here)

C
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR OR REAR RH DOOR) (Click here)
A

FIT WINDOW GLASS CORRECTLY (REMOVE FOREIGN MATTER CAUSING IMPROPER FIT OR REPLACE)