Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type)

NAVIGATION SYSTEM (for Radio and Display Type) > Vehicle Speed Signal Circuit between Radio Receiver and Extension Module

for Preparation Click here


DESCRIPTION

The navigation ECU receives a vehicle speed signal from the radio and display receiver assembly and information from the navigation antenna assembly, and then adjusts vehicle position.

WIRING DIAGRAM


E261261E46


INSPECTION PROCEDURE

1.INSPECT NO. 1 NAVIGATION WIRE
  1. Remove the No. 1 navigation wire (Click here)

  1. Disconnect the k2 radio and display receiver assembly connector.

  1. Disconnect the k3 navigation ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    k2-2 (SPD0) - k3-5 (SPD)
    Always
    Below 1 Ω
    k2-2 (SPD0) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE NO. 1 NAVIGATION WIRE (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)