Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for Radio and Display Type)

NAVIGATION SYSTEM (for Radio and Display Type) > Microphone Circuit between Radio Receiver and Extension Module

for Preparation Click here


DESCRIPTION

This circuit sends a microphone voice signal from the navigation ECU to the radio and display receiver assembly.
Using this circuit, the navigation ECU disables the microphone function of the radio and display receiver assembly to receive a microphone voice signal from the telephone microphone assembly.

WIRING DIAGRAM


E277822E03


INSPECTION PROCEDURE

1.CHECK NO. 1 NAVIGATION WIRE
  1. Disconnect the k2 radio and display receiver assembly connector.

  1. Disconnect the k3 navigation ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    k2-5 (MIC+) - k3-16 (MIC+)
    Always
    Below 1 Ω
    k2-6 (MIC-) - k3-17 (MIC-)
    Always
    Below 1 Ω
    k2-1 (SLD4) - k3-18 (MSHLD)
    Always
    Below 1 Ω
    k2-5 (MIC+) - Body Ground
    Always
    10 kΩ or higher
    k2-6 (MIC-) - Body Ground
    Always
    10 kΩ or higher
    k2-1 (SLD4) - Body Ground
    Always
    10 kΩ or higher



NG
REPLACE NO. 1 NAVIGATION WIRE (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)