DTC P019011 Fuel Rail Pressure Sensor "A" Circuit Short to Ground |

| DTC No. | DTC Detection Condition | Trouble Area |
| P019011 | The fuel pressure sensor output voltage is less than 0.293 V for 3 seconds or more (1 trip detection logic). |
|
| DTC No. | Fuel Pressure (High) | Malfunction |
| P019011 | Approximately 0 kPag |
|
| Required Sensors/Components | Fuel pressure sensor |
| Frequency of Operation | Continuous |
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.CHECK HARNESS AND CONNECTOR (FUEL PRESSURE SENSOR - ECM) |
Disconnect the ECM connector.
Disconnect the fuel pressure sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G2-1 (VC) - E96-136 (VCPR) | Always | Below 1 Ω |
| G2-3 (PR) or E96-103 (PR) - Body ground and other terminals | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.CHECK TERMINAL VOLTAGE (POWER SOURCE OF FUEL PRESSURE SENSOR) |
![]() |
Disconnect the fuel pressure sensor connector.
| *a | Front view of wire harness connector (to Fuel Pressure Sensor) |
Turn the engine switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G2-1 (VC) - G2-2 (E2) | Engine switch on (IG) | 4.75 to 5.25 V |
|
| ||||
| OK | ||
| ||