DTC P060E49 Internal Control Module Throttle Position Performance Internal Electronic Failure |
DTC P061E49 Internal Control Module Brake Signal Internal Electronic Failure |
| DTC No. | DTC Detection Condition | Trouble Area |
| P060E49 | Either of the following conditions is met (1 trip detection logic):
| ECM |
| P061E49 | Either of the following conditions is met (1 trip detection logic):
| ECM |
| Required Sensors/Components | ECM |
| Frequency of Operation | Continuous |
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ OUTPUT DTC (DTC P060E49 OR P061E49) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTCs.
Turn the GTS off.
Turn the engine switch off.
Disconnect the GTS.
Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
Connect the cable to the negative (-) battery terminal.
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Wait for 16 seconds or more.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTCs are not output | A |
| DTC P060E49 or P061E49 is output | B |
|
| ||||
| A | ||
| ||