DTC P070312 Brake Switch "B" Circuit Short to Battery |
| DTC No. | DTC Detection Condition | Trouble Area |
| P070312 | The stop light switch assembly remains on even when the vehicle repeats 5 cycles of STOP (less than 3 km/h [1.86 mph]) and GO (30 km/h [18.65 mph] or more) (2 trip detection logic). |
|
| Required Sensors/Components (Main) | Stop light switch assembly |
| Required Sensors/Components (Related) | Speed sensor |
| Frequency of Operation | Continuous |

| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.READ VALUE USING GTS (STOP LIGHT SW) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / All Data / Stop Light SW.
Read the Data List displayed on the GTS.
| GTS Display | Measurement Item/Range (display) | Normal Condition |
| Stop Light SW | Stop light switch status: ON or OFF |
|
|
| ||||
| OK | ||
| ||
| 2.CHECK STOP LIGHT SWITCH ASSEMBLY INSTALLATION |
Check the stop light switch installation .
|
| ||||
| OK | |
| 3.INSPECT STOP LIGHT SWITCH ASSEMBLY |
Inspect the stop light switch assembly (Click here).
|
| ||||
| OK | |
| 4.CHECK TERMINAL VOLTAGE (STP VOLTAGE) |
Disconnect the ECM connector.

| *a | Brake pedal depressed | *b | Brake pedal released |
| *c | Front view of wire harness connector (to ECM) | - | - |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A84-9 (STP) - Body ground | Brake pedal released | Below 1.5 V |
| Brake pedal depressed | 7.5 to 14 V |
|
| ||||
| OK | ||
| ||