DTC P21201C Throttle/Pedal Position Sensor/Switch "D" Circuit Voltage Out of Range |
DTC P212099 Throttle/Pedal Position Sensor/Switch "D" Exceeded Learning Limit |
| DTC No. | DTC Detection Condition | Trouble Area |
| P21201C | Difference between VPA and VPA2 is greater than or equal to the specified value (1 trip detection logic). |
|
| P212099 | Difference between VPA and VPA2 is less than 0.4 V, or higher than 1.2 V (learned value of accelerator off position) (1 trip detection logic). |
|
| Required Sensors/Components | Accelerator pedal sensor assembly |
| Frequency of Operation | Continuous |

| GTS Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P21201C AND/OR P212099) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P21201C and/or P212099 is output | A |
| DTC P21201C and/or P212099 and other DTCs are output | B |
|
| ||||
| A | |
| 2.READ VALUE USING GTS (ACCELERATOR POSITION SENSOR VOLTAGE) |
![]() |
Connect the GTS to the DLC3.
| *a | Fully Depressed |
| *b | Fully Released |
Turn the engine switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Engine / Data List / All Data / Accelerator Position Sensor No.1 Voltage and Accelerator Position Sensor No.2 Voltage.
Read the values displayed on the GTS.
| Accelerator Pedal Operation | Accelerator Position Sensor No.1 Voltage | Accelerator Position Sensor No.2 Voltage |
| Fully Released | 0.5 to 1.1 V | 1.2 to 2.0 V |
| Fully Depressed | 2.6 to 4.5 V | 3.4 to 4.75 V |
|
| ||||
| OK | ||
| ||
| 3.REPLACE ACCELERATOR PEDAL SENSOR ASSEMBLY |
Replace the accelerator pedal sensor assembly (Click here).
| NEXT | |
| 4.CHECK WHETHER DTC OUTPUT RECURS (DTC P21201C AND/OR P212099) |
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the GTS on.
Clear the DTCs.
Turn the engine switch off and wait for at least 30 seconds.
Turn the engine switch on (IG) and turn the GTS on.
Drive the vehicle in accordance with the driving pattern described in Confirmation Driving Pattern.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P21201C and/or P212099 is output | A |
| DTCs are not output | B |
|
| ||||
| A | ||
| ||