Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL TIMING CHAIN COVER OIL SEAL
  1. Apply MP grease to the lip of a new timing chain cover oil seal.

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not allow MP grease to contact the dust seal.



    A338522E01
  1. Using SST and a hammer, tap in the timing chain cover oil seal.
    Text in Illustration 
    *a
    Standard Depth (from edge of the timing chain cover sub-assembly)

    SST
    09636-20010  

    Standard Depth:
    -0.75 to -1.45 mm (-0.0295 to -0.0571 in.)

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not tap in the timing chain cover oil seal at an angle.



2. INSTALL CRANKSHAFT PULLEY
  1. Align the crankshaft pulley key with the key groove of the crankshaft pulley.



    A284349E02
  1. Using SST, hold the crankshaft pulley and install the crankshaft pulley set bolt.
    Text in Illustration 
    *a
    Hold
    *b
    Turn
    *c
    Washers

    SST
    09213-54015   (09214-00030)
    09213-70011  
    09330-00021  

    Torque:
    260 N*m{ 2651 kgf*cm , 192 ft.*lbf }

    HINT:
    Insert a few washers (total thickness: approximately 5.0 mm (0.197 in.)) between SST (09213-70011) and SST (09214-00030).



3. INSTALL V-RIBBED BELT
(Click here)