Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL

FRONT CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE V-RIBBED BELT
(Click here)


2. REMOVE CRANKSHAFT PULLEY


    A284348E02
  1. Using SST, hold the crankshaft pulley and loosen the crankshaft pulley set bolt. Further loosen the crankshaft pulley set bolt until 2 or 3 threads remain screwed into the crankshaft.
    Text in Illustration 
    *a
    Hold
    *b
    Turn
    *c
    Washers

    SST
    09213-54015   (09214-00030)
    09213-70011  
    09330-00021  

    HINT:
    Insert a few washers (total thickness: approximately 5.0 mm (0.197 in.)) between SST (09213-70011) and SST (09214-00030).



    A210637E02
  1. Using SST and the crankshaft pulley set bolt, remove the crankshaft pulley and crankshaft pulley set bolt.
    Text in Illustration 
    *1
    Crankshaft Pulley Set Bolt
    *a
    Hold
    *b
    Turn

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05011)

    HINT:
    Apply lubricant to the threads and end of SST.



3. REMOVE TIMING CHAIN COVER OIL SEAL


    A195807E02
  1. Using a screwdriver, pry out the timing chain cover oil seal.
    Text in Illustration 
    *a
    Protective Tape

    NOTICE:
    Do not damage the surface of the timing chain cover oil seal press fit hole or the crankshaft.

    HINT:
    Tape the screwdriver tip before use.