FUEL INJECTOR (for Port Injection) > REMOVAL |
| 1. PRECAUTION |
| 2. DISCHARGE FUEL SYSTEM PRESSURE |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE FUEL PUMP PROTECTOR |
![]() |
Remove the 2 bolts and fuel pump protector from the cylinder head cover sub-assembly.
| 5. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY |
| 6. REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY |
![]() |
Using a 17 mm union nut wrench, loosen the 2 union nuts of the No. 1 fuel pipe sub-assembly.
![]() |
Loosen the 2 bolts of the fuel pump with seal sub- assembly.
Remove the No. 1 fuel pipe sub-assembly from the fuel delivery pipe sub-assembly and fuel pump with seal sub- assembly.
| 7. DISCONNECT FUEL TUBE SUB-ASSEMBLY |
Disconnect the fuel tube sub-assembly from the fuel delivery pipe.
![]() |
Pull off the fuel tube connector cover.
| *a | Fuel Tube Connector Cover |
![]() | Pull off |
![]() |
Pinch the retainer of the fuel tube connector, and then pull the fuel tube connector off of the fuel pipe.
| *a | Retainer |
| *b | Fuel Tube Connector |
| *c | Nylon Tube |
| *d | O-ring |
| *e | Fuel Pipe |
![]() | Pinch |
![]() | Pull |
If the fuel tube connector and fuel pipe are stuck, push and pull the fuel tube connector to release it. Pull the fuel tube connector off of the fuel pipe carefully.
Check that there is no foreign matter on the sealing surfaces of the disconnected fuel lines. Clean them if necessary.
Cover the disconnected fuel pipe and fuel tube connector with plastic bags to prevent damage and contamination.
| 8. DISCONNECT NO. 2 VENTILATION HOSE |
![]() |
Slide the clip and disconnect the No. 2 ventilation hose from the PCV valve (ventilation valve sub-assembly).
| 9. DISCONNECT NO. 8 ENGINE WIRE |
![]() |
Disconnect the 4 port fuel injector assembly connectors.
Disengage the 3 clamps to disconnect the No. 8 engine wire from the fuel delivery pipe.
| 10. REMOVE FUEL DELIVERY PIPE |
![]() |
Remove the 2 bolts and fuel delivery pipe with the port fuel injector assemblies.
| 11. REMOVE FUEL DELIVERY SPACER |
![]() |
Remove the 2 fuel delivery spacers from the cylinder head sub-assembly.
| 12. REMOVE INJECTOR VIBRATION INSULATOR |
![]() |
Remove the 4 injector vibration insulators from the cylinder head sub-assembly.
| 13. REMOVE PORT FUEL INJECTOR ASSEMBLY |
![]() |
Pull the 4 port fuel injector assemblies out of the fuel delivery pipe.
Remove the O-ring from each port fuel injector assembly.
Attach a tag or label with the corresponding cylinder number to each port fuel injector assembly so that they can be installed to their original locations.