Home › Engine / Hybrid System ยท 6AR-FSE › FUEL › FUEL INJECTOR (for Direct Injection)

FUEL INJECTOR (for Direct Injection) > REMOVAL

for Preparation Click here



1. REMOVE INTAKE MANIFOLD
(Click here)


2. REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY


    A337375
  1. Using a 17 mm union nut wrench, loosen the 2 union nuts of the No. 1 fuel pipe sub-assembly.



    A337377
  1. Loosen the 2 bolts of the fuel pump with seal sub- assembly.

  1. Remove the No. 1 fuel pipe sub-assembly from the fuel delivery pipe sub-assembly and fuel pump with seal sub- assembly.



3. DISCONNECT NO. 5 ENGINE WIRE


    A337370
  1. Remove the 2 bolts and disconnect the No. 5 engine wire from the fuel delivery pipe sub- assembly.

  1. Disconnect the 4 direct fuel injector assembly connectors.

  1. Disconnect the fuel pressure sensor connector.



4. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY


    A337371
  1. Remove the 3 bolts, 2 nuts and fuel delivery pipe sub-assembly with the direct fuel injector assemblies.
    Text in Illustration 
    V100135
    Bolt
    V100136
    Nut

    NOTICE:
    1. Make sure not to touch or strike the tips of the direct fuel injector assemblies.
    1. Pull and remove the fuel delivery pipe sub-assembly in a straight line without tilting it.



5. REMOVE DIRECT FUEL INJECTOR ASSEMBLY


    A335649E01
  1. Secure the fuel delivery pipe sub-assembly in a vise between aluminum plates and pull out the 4 direct fuel injector assemblies.

    NOTICE:
    1. Pull and remove each direct fuel injector assembly in a straight line to avoid damaging the seal surface of the fuel delivery pipe sub-assembly O-ring.
    1. Attach a tag or label with the corresponding cylinder number to each direct fuel injector assembly so that they can be installed to their original locations.

  1. Remove the nozzle holder clamp from each direct fuel injector assembly.

  1. Using needle nose pliers, remove the No. 3 fuel injector back-up ring from each direct fuel injector assembly.

  1. Remove the O-ring and No. 1 fuel injector back-up ring from each direct fuel injector assembly.

  1. Remove the C-ring and injector vibration insulator from each direct fuel injector assembly.



6. REMOVE FUEL INJECTOR SEAL


    A273082
  1. Using the tip of needle nose pliers, pinch and pull the fuel injector seal at several points to stretch it.

    NOTICE:
    1. Excessively pinching the fuel injector seal may damage the groove of the direct fuel injector assembly.
    1. If a direct fuel injector assembly is dropped or the tip of a direct fuel injector assembly is struck, replace it with a new one.

  1. Remove the fuel injector seal from each direct fuel injector assembly.