Home › Engine / Hybrid System ยท 6AR-FSE › INTAKE / EXHAUST › INTAKE MANIFOLD

INTAKE MANIFOLD > REMOVAL

for Preparation Click here



1. REMOVE WINDSHIELD WIPER MOTOR AND LINK
(Click here)


2. REMOVE FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY


  1. w/ Windshield Deicer System:



      C309273
    1. Disengage the 2 clamps.

    2. Disconnect the connector and separate the wire harness from the front outer cowl top panel sub-assembly.



  1. w/ Heated Windshield Defroster System:



      C309274
    1. Disengage the 4 clamps.

    2. Disconnect the 2 connectors and separate the wire harness from the front outer cowl top panel sub-assembly.



    C239198
  1. Disengage the 2 clamps and separate the wire harness from the front outer cowl top panel sub-assembly.



    C239185
  1. Remove the 10 bolts and front outer cowl top panel sub-assembly.



3. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
(Click here)


4. DISCONNECT NO. 2 VENTILATION HOSE


    A338722
  1. Slide the clip and disconnect the No. 2 ventilation hose from the intake manifold.



5. REMOVE VACUUM SENSOR (MANIFOLD ABSOLUTE PRESSURE SENSOR)


    A338723
  1. Disconnect the vacuum sensor (manifold absolute pressure sensor) connector.

  1. Disconnect the vacuum hose from the intake manifold.

  1. Remove the bolt and vacuum sensor (manifold absolute pressure sensor) from the intake manifold.



6. REMOVE PURGE VALVE (PURGE VSV)


    A338728E01
  1. Slide the clip and disconnect the fuel vapor hose from the intake manifold.
    Text in Illustration 
    *1
    Fuel Vapor Hose
    *2
    Fuel Vapor Feed Hose Assembly

  1. Slide the clip and disconnect the fuel vapor feed hose assembly from the purge valve (purge VSV).

  1. Disconnect the purge valve (purge VSV) connector.

  1. Remove the bolt and purge valve (purge VSV) from the intake manifold.



7. REMOVE FUEL PUMP PROTECTOR


    A337351
  1. Remove the 2 bolts and fuel pump protector from the cylinder head cover sub-assembly.



8. REMOVE NO. 2 EGR PIPE


    A338724
  1. Disengage the 2 wire harness clamps from the No. 2 EGR pipe.



    A338725
  1. Remove the 4 bolts and No. 2 EGR pipe from the EGR valve assembly and intake manifold.



    A338726
  1. Remove the No. 2 EGR pipe gasket from the EGR valve assembly.



    A338727
  1. Remove the EGR inlet gasket from the intake manifold.



9. DISCONNECT ENGINE WIRE


    A338729
  1. Disengage the 7 wire harness clamps from the intake manifold.



10. REMOVE INTAKE MANIFOLD


    A338730
  1. Remove the 6 bolts and intake manifold from the cylinder head sub-assembly.



    A338731
  1. Remove the manifold gasket from the intake manifold.