FUEL PUMP > DISASSEMBLY |
| 1. REMOVE FUEL SENDER GAUGE ASSEMBLY |
![]() |
Disconnect the fuel sender gauge assembly connector.
![]() |
Push the claw (A) of the fuel sender gauge assembly, and then pull up the fuel sender gauge assembly to remove it.
| 2. REMOVE LOWER FUEL TANK CASE SUB-ASSEMBLY |
![]() |
Disconnect the fuel pump harness connector.
Disconnect the fuel pump harness from the fuel suction plate sub-assembly.
![]() |
Using needle nose pliers, remove the E-ring.
| *1 | E-ring |
![]() |
Disengage the 4 claws of the No. 1 fuel suction support and remove the lower fuel tank case sub- assembly from the fuel suction plate sub-assembly with the fuel filter.
| *a | Tube |
Remove the spring from the shaft of the fuel suction plate sub-assembly.
| 3. REMOVE NO. 1 FUEL SUCTION SUPPORT |
![]() |
Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the No. 1 fuel suction support from the fuel filter.
| *a | Protective Tape |
| 4. REMOVE FUEL PUMP |
![]() |
Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws, and remove the fuel pump from the fuel filter.
| *a | Fuel Filter |
| *b | Suction Filter |
| *c | Protective Tape |
![]() |
Disconnect the fuel pump harness connector to remove the fuel pump harness from the fuel pump.
![]() |
Remove the O-ring and fuel pump spacer from the fuel pump.
| *1 | O-ring |
| *2 | Fuel Pump Spacer |
| *a | 5.0 mm (0.197 in.) |