Home › Engine / Hybrid System ยท 6AR-FSE › FUEL › FUEL PUMP ECU

FUEL PUMP ECU > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE LUGGAGE COMPARTMENT FLOOR MAT
  1. Remove the luggage compartment floor mat.



4. REMOVE BAGGAGE HOLDER NET (w/ Partition Net)
  1. Remove the baggage holder net.



5. REMOVE REAR FLOOR FINISH PLATE


    B294805
  1. Remove the 5 clips.



    B294806
  1. Disengage the 4 clips and remove the rear floor finish plate.



6. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK


    B281706E01
  1. Push the 2 pins and remove the 2 No. 1 luggage compartment trim hooks.
    Text in Illustration 
    *1
    Pin



7. REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH


    B281707
  1. Remove the 3 clips.

  1. Disengage the fastener and remove the luggage compartment inner trim cover LH.



8. REMOVE FUEL PUMP CONTROL ECU ASSEMBLY


    A283936
  1. Remove the 2 nuts.

  1. Disconnect the fuel pump control ECU assembly connector and remove the fuel pump control ECU assembly.

    NOTICE:
    Do not reuse the fuel pump control ECU assembly if it has been dropped or subjected to a severe impact.

    HINT:
    If a malfunction such as pump lock occurs and the fuel pump is damaged, excessive current may be continuously applied to the fuel pump control ECU assembly, damaging its internal parts. Make sure to replace the fuel pump control ECU assembly at the same time when replacing the fuel pump.