Home › Engine / Hybrid System ยท 6AR-FSE › FUEL › FUEL SENDER GAUGE ASSEMBLY

FUEL SENDER GAUGE ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
(Click here)


2. REMOVE FUEL SENDER GAUGE ASSEMBLY


    A136021
  1. Disconnect the fuel sender gauge assembly connector.



    A136022E01
  1. Push the claw (A) of the fuel sender gauge assembly, and then pull up the fuel sender gauge assembly to remove it.

    NOTICE:
    1. Do not touch the resistance plate or contacts of the fuel sender gauge assembly.
    2. Be careful not to bend the arm of the fuel sender gauge assembly.