FUEL PUMP > REMOVAL |
| 1. PRECAUTION |
| 2. DISCHARGE FUEL SYSTEM PRESSURE |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE REAR SEAT CUSHION ASSEMBLY |
![]() |
Lift up the front edge of the rear seat cushion assembly as shown in the illustration and disengage the 2 rear seat cushion frame hooks on the front side of the rear seat cushion assembly from the 2 rear seat cushion lock hooks.
| a | 100 mm (3.94 in.) or less |
Pass the 2 rear seat inner belt assemblies through the rear seat cushion assembly and remove the rear seat cushion assembly.
| 5. REMOVE REAR SEAT CUSHION LOCK HOOK |
![]() |
Disengage the 2 claws to remove the rear seat cushion lock hook as shown in the illustration.
| 6. REMOVE REAR FLOOR SERVICE HOLE COVER |
![]() |
Using a clip remover with its tip wrapped with protective tape, remove the rear floor service hole cover and butyl tape.
| *a | Protective Tape |
Disconnect the fuel pump connector.
| 7. DISCONNECT FUEL PUMP TUBE SUB-ASSEMBLY |
![]() |
Remove the tube joint clip, and pull off the fuel tube joint of the fuel pump tube sub-assembly.
| *1 | Tube Joint Clip |
| *2 | Fuel Pump Tube Sub-assembly |
| *3 | Fuel Suction Plate Sub-assembly |
| *a | Fuel Tube Joint |
| *b | O-ring |
| *c | Nylon Tube |
![]() | Pull off |
![]() | Pull off |
| 8. REMOVE FUEL TANK VENT TUBE SET PLATE |
![]() |
Remove the 8 bolts and fuel tank vent tube set plate.
| 9. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY |
![]() |
Remove the fuel suction tube with pump and gauge assembly from the fuel tank assembly.
![]() |
Remove the fuel suction tube set gasket from the fuel suction tube with pump and gauge assembly.
| *1 | Fuel Suction Tube Set Gasket |