Home › Power Source / Network · 6AR-FSE BATTERY / CHARGING › CHARGING SYSTEM

DTC    P161A87    Lost Communication with Alternator Missing Message

for Preparation Click here


DESCRIPTION

The ECM communicates with the generator assembly via LIN communication. If a LIN communication error is detected, the ECM stores this DTC.

DTC No.
DTC Detection Condition
Trouble Area
P161A87
Generator assembly or ECM communication stop for about 17 minutes or more with the engine switch on (IG).
(1 trip detection logic)
  1. Wire harness and connector
  2. Generator assembly
  3. ECM

WIRING DIAGRAM


A348065E03


INSPECTION PROCEDURE

1.CHECK CHARGING SYSTEM
  1. Check the charging system (Click here).



NG
REPAIR OR REPLACE CHARGING SYSTEM
OK


2.CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)
  1. Disconnect the E96 ECM connector.

  1. Disconnect the E99 generator assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Open):

    Tester Connection
    Condition
    Specified Condition
    E96-61 (LIN) - E99-2 (LIN)
    Always
    Below 1 Ω


    Standard Resistance (Check for Short):

    Tester Connection
    Condition
    Specified Condition
    E96-61 (LIN) or E99-2 (LIN) - body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE GENERATOR ASSEMBLY (Click here)