Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE (for Intake Side)

CAMSHAFT OIL CONTROL VALVE (for Intake Side) > INSTALLATION

for Preparation Click here



1. SET NO. 1 CYLINDER TO TDC/COMPRESSION


    A338578E03
  1. Turn the crankshaft pulley until its timing notch (groove) is aligned with the timing mark "0" of the timing chain cover sub-assembly.
    Text in Illustration 
    *a
    Timing Mark "0"
    *b
    Timing Notch (Groove)



    A338579E02
  1. Check that the protrusion of the camshaft timing gear assembly is at the top.
    Text in Illustration 
    *a
    Protrusion
    *b
    Top

    HINT:
    If the protrusion is not at the top, rotate the crankshaft pulley 360° clockwise and align the timing notch (groove) with the timing mark "0" again.



2. INSTALL CAMSHAFT TIMING GEAR BOLT


A378076E01

NOTICE:
There are different types of camshaft timing gear bolts. Make sure to check the identification mark to determine the tightening torque.
Identification Mark 
Item
Identification Mark Stamp
Type A
A
Type B
D

Text in Illustration 
*a
Identification Mark Stamp


    A337898
  1. Apply engine oil to the areas of the camshaft timing gear bolt shown in the illustration.

  1. Temporarily install the camshaft timing gear bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    If the camshaft timing gear bolt has been struck or dropped, replace it.

    HINT:
    Make sure that the flange part of the camshaft timing gear bolt contacts the entire circumference of the camshaft timing gear assembly.

  1. Loosen the camshaft timing gear bolt 60 to 180°.

  1. Turn the crankshaft pulley clockwise 60 to 120°.



    A338580E03
  1. Using SST, hold the crankshaft pulley.
    Text in Illustration 
    *a
    Washers

    SST
    09213-54015   (09214-00030)
    09213-70011  
    09330-00021  

    HINT:
    Insert a few washers (total thickness: approximately 5.0 mm (0.197 in.)) between SST (09213-70011) and SST (09214-00030).

  1. Tighten the camshaft timing gear bolt.

    Torque:
    Type A:
    120 N*m{ 1224 kgf*cm , 89 ft.*lbf }
    Type B:
    95 N*m{ 969 kgf*cm , 70 ft.*lbf }



3. INSTALL CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY
(Click here)


4. INSTALL FRONT FENDER APRON SEAL RH
  1. Install the front fender apron seal RH with the 2 bolts and clip.



5. INSPECT FOR ENGINE OIL LEAK
  1. Start the engine. Make sure that there are no engine oil leaks from the area that was worked on.