Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › CAMSHAFT OIL CONTROL VALVE (for Intake Side)

CAMSHAFT OIL CONTROL VALVE (for Intake Side) > REMOVAL

for Preparation Click here



1. REMOVE FRONT FENDER APRON SEAL RH
  1. Remove the 2 bolts, clip and front fender apron seal RH.



2. REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY
(Click here)


3. SET NO. 1 CYLINDER TO TDC/COMPRESSION


    A338578E03
  1. Turn the crankshaft pulley until its timing notch (groove) is aligned with the timing mark "0" of the timing chain cover sub-assembly.
    Text in Illustration 
    *a
    Timing Mark "0"
    *b
    Timing Notch (Groove)



    A338579E02
  1. Check that the protrusion of the camshaft timing gear assembly is at the top.
    Text in Illustration 
    *a
    Protrusion
    *b
    Top

    HINT:
    If the protrusion is not at the top, rotate the crankshaft pulley 360° clockwise and align the timing notch (groove) with the timing mark "0" again.



4. REMOVE CAMSHAFT TIMING GEAR BOLT


    A338580E03
  1. Using SST, hold the crankshaft pulley.
    Text in Illustration 
    *a
    Washers

    SST
    09213-54015   (09214-00030)
    09213-70011  
    09330-00021  

    HINT:
    Insert a few washers (total thickness: approximately 5.0 mm (0.197 in.)) between SST (09213-70011) and SST (09214-00030).



    A337986
  1. Remove the camshaft timing gear bolt.

    NOTICE:
    If the camshaft timing gear bolt has been struck or dropped, replace it.