Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › IGNITION COIL AND SPARK PLUG

IGNITION COIL AND SPARK PLUG > INSTALLATION

for Preparation Click here



1. INSTALL SPARK PLUG

HINT:
Perform "Inspection After Repair" after replacing a spark plug (Click here).

  1. Install the 4 spark plugs to the cylinder head sub-assembly.

    Torque:
    25 N*m{ 255 kgf*cm , 18 ft.*lbf }

    NOTICE:
    If a spark plug has been struck or dropped, replace it.

    HINT:
    Install the same parts to their original positions.



2. INSTALL IGNITION COIL ASSEMBLY

HINT:
Perform "Inspection After Repair" after replacing an ignition coil assembly (Click here).

  1. Install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    If an ignition coil assembly has been struck or dropped, replace it.

    HINT:
    Install the same parts to their original positions.

  1. Connect the 4 ignition coil assembly connectors.



3. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
  1. Engage the 3 grommets to install the No. 1 engine cover sub-assembly.



4. PERFORM INITIALIZATION
  1. Perform "Inspection After Repair" after replacing an ignition coil assembly and spark plug (Click here).