ENGINE COOLANT TEMPERATURE SENSOR > INSTALLATION |
| 1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR |
Install a new gasket to the engine coolant temperature sensor.
![]() |
Using SST, install the engine coolant temperature sensor to the cylinder head sub-assembly.
Connect the engine coolant temperature sensor connector.
| 2. INSTALL AIR CLEANER CASE SUB-ASSEMBLY |
![]() |
Insert the projection of the air cleaner case sub-assembly into the hole of the No. 1 air cleaner bracket as shown in the illustration.
| *a | Hole |
| *b | Projection |
Install the 2 bolts.
Connect the wire harness clamp.
| 3. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
Install the air cleaner filter element sub-assembly to the air cleaner case sub-assembly.
| 4. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE |
Connect the air cleaner cap with air cleaner hose to the throttle body with motor assembly.
Install the air cleaner cap with air cleaner hose with the 2 guides and 2 air cleaner cap clamps.
Tighten the hose clamp.
Connect the union to connector tube hose to the air cleaner hose sub-assembly.
Engage the wire harness clamp.
Connect the mass air flow meter sub-assembly connector.
Engage the ventilation hose clamp.
Connect the ventilation hose to the cylinder head cover sub-assembly and slide the clip to secure it.
| 5. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY |
Engage the 3 grommets to install the No. 1 engine cover sub-assembly.
| 6. ADD ENGINE COOLANT |
Tighten the radiator drain cock plug by hand.
Slowly fill the radiator assembly with engine coolant.
Remove the reserve tank cap.
Slowly pour engine coolant into the radiator reserve tank assembly until it reaches the full line.
Squeeze the No. 1 radiator hose and No. 2 radiator hose several times by hand, and then check the level of the engine coolant.
If the engine coolant level is low, add engine coolant.
Install the radiator cap sub-assembly and reserve tank cap.
Bleed air from the cooling system.
Warm up the engine until the thermostat opens. While the thermostat is open, circulate the engine coolant for several minutes.
Maintain the engine speed at 2500 to 3000 rpm.
Squeeze the No. 1 radiator hose and No. 2 radiator hose several times by hand to bleed air from the cooling system.
Stop the engine, and wait until the engine coolant cools down.
Add engine coolant to the full line on the radiator reserve tank assembly.
| 7. INSPECT FOR COOLANT LEAK |
Remove the radiator cap sub-assembly.
![]() |
Fill the radiator assembly with engine coolant, and then install a radiator cap tester.
| *a | Radiator Cap Tester |
Warm up the engine.
Pump the radiator cap tester to 118 kPa (1.2 kgf/cm2, 17 psi), and then check that the pressure does not drop.
Remove the radiator cap tester.
Install the radiator cap sub-assembly.
| 8. PERFORM INITIALIZATION |