Home › Engine / Hybrid System ยท 6AR-FSE › ENGINE CONTROL › KNOCK SENSOR

KNOCK SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL KNOCK CONTROL SENSOR

HINT:
Perform "Inspection After Repair" after replacing the knock control sensor (Click here).



    A338028E01
  1. Install the knock control sensor to the cylinder block sub-assembly with the bolt so that the knock control sensor installation position is as shown in the illustration.
    Text in Illustration 
    *a
    Top
    *b
    Engine Front
    *c
    7°
    *d
    10°

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }

    NOTICE:
    If the knock control sensor has been struck or dropped, replace it.

  1. Connect the knock control sensor connector.



2. PERFORM INITIALIZATION
  1. Perform "Inspection After Repair" after replacing the knock control sensor (Click here).