AIR FUEL RATIO SENSOR > INSTALLATION |
| 1. INSTALL AIR FUEL RATIO SENSOR |
![]() |
Using SST, install the air fuel ratio sensor to the exhaust manifold.
| *a | Torque Wrench Fulcrum Length |
Connect the air fuel ratio sensor connector.
Engage the 3 wire harness clamps.
| 2. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR |
Install the No. 1 exhaust manifold heat insulator to the exhaust manifold converter sub-assembly (TWC: Front Catalyst) with the 4 bolts.
| 3. INSPECT FOR EXHAUST GAS LEAK |
Perform Inspection After Repair after repairing an exhaust gas leak (Click here).
| 4. PERFORM INITIALIZATION |